Troubleshooting - Omega Lift 43000 Operating Instructions & Parts Manual

Lubrication
A periodic coating of light lubricating oil to pivot points, axles and hinges will help to prevent rust and assure that
casters and pump assemblies move freely.
Cleaning
Periodically check the pump piston and ram for signs of rust or corrosion. Clean as needed and wipe with an oily
cloth.
Note: Never use sandpaper or abrasive material on these surfaces!
Storage
When not in use, store the jack with saddle fully lowered.

TROUBLESHOOTING

Symptom
Jack will not lift load
Jack will lift, but not maintain
pressure
Jack will not lower after
unloading
Poor lift performance
Jack will not lift to full extension • Fluid level low
Possible Causes
• Release valve not tightly closed
• Load is too heavy
• Release valve not tightly closed
• Hydraulic unit malfunction
• Reservoir overfilled
• Linkage binding
• Fluid level low
• Air trapped in system
• Ensure release valve tightly closed
• Consider higher capacity jack
• Ensure release valve tightly closed
• Discontinue use, contact your local
SFA Companies Representative or visit
www.sfacompanies.com to locate your
nearest store.
• Ensure load is removed, then drain fluid
to proper level
• Clean and lubricate moving parts
• Ensure proper fluid level
• Follow Bleeding/Venting procedure on
page 3
• Ensure proper fluid level
5
Corrective Action