Programming Of The Basic Adjustments - BLUM TC Series Operating Instructions Manual

3.7 Programming of the basic adjustments

In this mode the basic adjustments can be
programming.

The position of the elements on the transparent ring may differ, see chapter 2.1.
CAUTION Risk of collision
If adjustments on the probe have been changed, the probe must be
paired again.
Probe pairing: see installation instructions IF59-A2 (P03.5900-000.011)
1. Remove batteries
2. Wait for 30 sec.
3. Insert batteries again (pls. observe pole position), put on cover of battery box.
The LED Status starts flashing. The basic adjustments are displayed. (display phase)
4. Change into programming mode during the display phase:
Hold magnetic pin on label „MODE" until the LED Status is changing from green to violet.
5. Change adjustments (SET)
Hold magnetic pin on label „SET"
6. Menu change (MODE)
Hold magnetic pin on label „MODE"
The LED Status (7) is shortly flashing violet to confirm the menu change
(7) LED Status
7. After the last menu the basic adjustments are repeated (3x MODE-SET). During the display
phase it can be changed again into the programming mode.
 by Blum-Novotest 2012
adjusted. The magnetic pin is required for
Mounting and commissioning
25