Using The Function Button; Using The Daylight View Function; Setting The Id Number Of The Remote Control - Panasonic PT-VW360 Operating Instructions Manual

Chapter 3 Basic Operations - Basic operations by using the remote control
3) Press the <P-TIMER> button again.
f The count is resumed.
Note
f Pressing the <P-TIMER> button for at least 3 seconds to release the P-TIMER function.
f For details, please refer to the [DISPLAY OPTION] menu → [P-TIMER] (x page 72).

Using the FUNCTION button

Some frequently used menu items can be assigned to the <FUNCTION> button on the remote control so that it
can be used as an shortcut button.
button
1) Press the <FUNCTION> button on the remote control.
To assign functions to the <FUNCTION> button
1) Press the <MENU> button on the control panel or the remote control to display the menu items (main
menu, sub-menu or details menu) you want to assign.
f Refer to "Navigating through the menu" (x page 52) for the operation of the menu.
2) Press and hold the <FUNCTION> button for 3 seconds or more.
Note
f After settings have been completed, the assigned menu item (main menu, sub-menu or details menu) will be displayed in [ASSIGNED
FUNCTION] of the operation guide under the menu.
f Perform the [PROJECTOR SETUP] menu → [FUNCTION BUTTON] (x page 78) when deallocating functions.

Using the Daylight View function

The Daylight View function improves the vividness of the image even if it is projected under a bright light.
button
1) Press the <DAYLIGHT VIEW> button on the remote control.
f It will switch each time you press the button, [ON] → [OFF] → [AUTO] → [ON]...
Note
f For details, please refer to the [PICTURE] menu → [DAYLIGHT VIEW] (x page 58).

Setting the ID number of the remote control

When you use the system with multiple projectors, you can operate all the projectors simultaneously or each
projector individually by using single remote control, if unique ID number is assigned to each projector.
After setting the ID number of the projector, set the same ID number to the remote control.
The factory default ID number of the projector is set to [ALL]. When using a single projector, press the <ID ALL>
button on the remote control. Also, you can control a projector by pressing the <ID ALL> button on the remote
control even if you do not know the projector ID.
buttons
1) Press the <ID SET> button on the remote control.
2) Within 5 seconds, press the one-digit ID number set on the projector using the number (<1> - <6>)
buttons.
f If you press the <ID ALL> button, you can control the projectors regardless of the ID number setting of the
projector.
ENGLISH - 49