Advertisement
1. Take the unit out of the shipping carton and remove all packaging materials. Check all
parts and accessories are included.
2. For installing, the location must have/be:
A level and steady surface.
¤
Sufficient space for air circulation around the unit.
¤
At least 50 cm away from any heat source.
¤
No direct sunlight.
¤
Avoid high-humidity areas and locations near water.
¤
1. Check the power switch is OFF.
2. Check the temperature control knob is come by OFF.
3. Check no foreign object is into the bathtub and place a drain board on it.
Pour water or hot water (approx. 3.5 liter) into the bathtub to the line displayed inside.
It is about 3.5 liters
in the position of
this line.
This line is a standard in the case of putting 12 of 180ml service bottles.
Adjust the quantity of water according to the bottle to be used.
However, please be sure to follow the warning and notes which have been
indicated below.
Do not add water to the limit of a bathtub. There is a risk of water
overflowing and it may result in a fire and/or electrical shock.
Do not heat empty bathtub. Failure to do so may result in a fire,
burns or malfunction.
4. Turn on the switch. The power lamp (Green) will light up.
水位
WARNING
WARNING
(Water Line)
Advertisement
