Pioneer DDJ-RB Service Manual page 30

1
1-5: Voltage value fluctuation range check mode
A
This mode is to monitor and indicate values of voltages (A/D conversion values) of various controls (faders and knobs).
[Controls to be tested]
The target controls of the test is faders and controls indicated in green in the figure below.
To change the target of the test, turn the rotary selector (BROWSE) clockwise or counterclockwise.
B
C
[Test procedures]
1. Select a test target by turning the rotary selector clockwise or counterclockwise.
At the beginning of this test mode, the control numbered 1 is selected.
As the rotary selector is turned by 1 click, the LED of the selected control will light in the order indicated below.
Clockwise rotation:
Counterclockwise rotation:
D
2. Which control is currently selected is indicated with lighting of the LED of the button corresponding to the selected control,
as shown in the figure above.
The LED with a number colored white corresponds to the control having the same number.
3. After the control to be tested is selected, press the rotary selector to start monitoring the A/D conversion values.
The reference value is the A/D conversion value monitored immediately after the monitoring started.
* The A/D conversion values being monitored are raw data.
4. The A/D conversion values being monitored are indicated with the CH level indicator.
If no fluctuations from the reference A/D value are monitored, all LEDs of the level indicator remain unlit.
E
In response to fluctuations from the reference A/D conversion value, the corresponding LEDs light.
After starting measurement. all A/D values of the controls are monitored and the result is displayed as described
in the following table. If you wish to measure again,
It will return again to this mode, then push the rotary selector (BROWSE).
* Lighting status of the level indicator shows that of the maximum value of plus and minus direction.
F
30
1
2
Rotary selector (BROWSE)
press the SHIFT button once move to another mode.
DDJ-RB
2
3
3
4
4