Table of Contents
Advertisement
Kneader assembly
After having assembled the parts for pasta production, you can assemble the kneader.
-
Place the reel (1) in the kneader unit, as shown in the figure
-
make sure that both locking devices (5) of the pasta maker are lifted and fit the locking pins (2) and (3) of the kneader in their
corresponding seats on the pasta maker
-
transmission must be properly connected in order to perform the final fastening operations: the transmission eccentric valve (C)
must be engaged in the pasta maker's power socket and the reel must also be mechanically connected to the screw conveyor; find
the transmission point of engagement with the aid of the relevant wrench (6), as shown in the figure.
1
2
C
3
Kneader assembly
-
finally, connect the kneader to its power supply and lock it into place by lowering both locking devices (5)
Use the flywheel (7) to adjust the thickness of the produced dough.
Accessory for tagliatelle noodles
An accessory with engraved rollers can be assembled at out-feed of the kneader for production of tagliatelle noodles.
-
fit the accessory (9) between the relevant kneader guides, as shown in the figure
-
pull the flywheel (10) and push the accessory to the farthest point
-
let go of the flywheel (10) and push the accessory for the tagliatelle while turning the flywheel (11) until transmission is connected
to the kneader's power socket.
The operator can lock the accessory into place by working on the pin of the flywheel (10) that slots into its seat (12).
Accessory for tagliatelle noodles
5
10
9
6
5
7
7
9
12
Advertisement
Table of Contents
