Part Disassembly - Univex Upasta-01 Operating And Maintenance Manual

- assemble the mold unit (6), centering the pins (8) of the ravioli unit with the matching holes of the mold
- turn the flywheel (9) to center transmission and to fully fit in the pins (8)
- using the figure on the page to the side as reference, grab the ravioli unit and slide it in, as far as possible, between the guides of
the kneader
- pull the flywheel (10) and push the unit to the farthest point
- release the flywheel (10)
- work the relevant wrench (11) and turn it while pushing the ravioli unit, to activate transmission in the power socket (12) of the
kneader.
The operator can lock the ravioli unit into place by working on the pin of the flywheel (10) that slots into the relevant seat.
Ravioli unit assembly (2/3)
ADJUSTMENTS
To make the ravioli, the flywheel (7) must be positioned on RAV.
The operator can adjust rack and pinion travel and consequently the quantity of filling for each ravioli with the aid of flywheel (14).

Part disassembly

To disassemble each machine part, carry out the same procedure (i.e. for their assembly) in reverse order.
Ravioli unit assembly (3/3)
6
8
9
8
11
12
11
8
7
10
14