Table of Contents
Advertisement
Pasta maker die assembly
After you have assembled the pasta production components, assemble the die, choosing it based on the desired product:
-
fit the pasta maker die (1) with the ring nut (2)
-
manually tighten the ring nut to the pasta maker as shown in the figure
-
further tighten the ring nut to a halt with the relevant wrench (3)
Pasta maker die assembly
Pasta cutter blade assembly
This accessory can only be used with the pasta maker die.
-
Assemble the blade (4) on the shaft of the blade unit, as shown in the figure
-
make sure the locking device (5) is lifted
-
fit the fixing pin (6) of the blade unit in its seat (7)
-
lower the locking device (5) to fasten the unit
-
engage the power connector (8) as shown in the figure.
Blade rotation speed, which determines product length, is adjustable using the potentiometer (9).
Pasta cutter blade assembly
2
1
4
7
6
5
8
9
8
3
Advertisement
Table of Contents
