Removing And Replacing Actuator; To Replace Actuator - Lippert Components ELECTRIC SLIDEOUT SYSTEM Operation And Service Manual

REMOVING AND REPLACING ACTUATOR

To replace actuator:

1. Disconnect manual crank shaft from end of motor assembly (Fig. A).
2. Disconnect motor wires from source. (Fig. A).
3. Take measurements A and B (Fig. B).
4. Remove all jam nuts (3 total) and stop can from threaded shaft on actuator (Fig. B)
5. Take note of mounting bolt locations and remove mounting bolts (Fig. C).
6. After everything is disconnected, slide actuator out of frame. To replace with new
actuator, follow previous directions in reverse.
15