EcoWater CWF Installation And Operating Manual page 8

leak could occur. Place the Housing and
Base right side-up with the Faucet
pointing Into the sink, Allow to stand for
1B minutes.
4. After 15 minutes, rinse the chlorine
solution from the Housing and Base by
tumtng on the COLD WATER faucet and
sliding the dlverter mechanism, The
system will be adequately rinsed when
no chlorine smell is present, Shut-oft the
cold water.
5. Again, hold the filter upside down,
unscrew the Filter Housing by turning .
clockwise and empty.
6, Remove the plastic wrap and label
from the replacement Filter and place it
In the Filter Housing so that the end with
the Cartridge O-Rings is facing outward
(toward the base). Make sure that the
Housing O-Ring is In the Filter Housing
and screw the Filter Housing onto the
Filter Base. (See Figure 12,)
7, Place the Filter System right side-up
with the Faucet pointing into the sink.
Rinse the Filter System for 5 minutes to
remove carbon fines and expel excess
air, Be certain to reset the meter after
you have comDletelv rinsed the system !!
RESETTING THEWATERMETER
CAUTION: After changing the filter you
must reset your meter to monitor the life
of your new filter. IT ISVERY IMPORTANT
TO USETHESAME KIND OF FILTERS THAT
WERE SHIPPED WITH YOUR SYSTEM.THE
VALUESTHAT ARE PROGRAMMED INTO
THE WATER METERAPPLY ONLY TO THE
SYSTEMMANUFACTURER'S FILTER.
TO RESET THE METER:
WARNING: Resetting the meter is
[E.e_Y_. Please read the following
instructions carefully.
Depress and hold the reset button until
"RESET? FILTER 1" appears (2 seconds)
then release the reset button. The
"RESET?" will be flashing. (See Figure 13.)
BUttON
Figure 13
Press grid hold the display button for 5
to complete the filter reset, (See
figure 14.) (Notice how the "?" disap-
pears after RESETand it stops flashing).
You will hear a confirming beep when
the water meter has been reset. The
Page 7