Starting Your Inverter Generator - BE I2500 Operation Manual

ccording to the connected load. The results are
s noise.

starting your inverter generator

TOR
ns off automatically when the load exceeds the
Starting Your Inverter generator
hin specified generator rated output if the DC circuit
�����������������
1. Turn the fuel cap lever to the ON position.
VENTKNOB
with an air vent knob to stop fuel flow. The air vent
ounterclockwise from the tigened position. This will
retor and the engine to run.
2. Set the fuel valve in the "ON" –position.
use, tigten the air vent knob clockwise until it is
3. To start a cold motor push the choke lever all the way to the left. To
restart a hot motor set the choke lever halfway.
The right choke position is the key to starting the motor. You may have to
practice a few times to use the choke correctly.
Position the choke completely to the right to restart a hot motor.
Position the choke about halfway to restart a warm motor.
WARNINg
Before starting the engine, disconnect any load.
4
1
2
1
2
OFF
Air Flow Knob
ON
ON
15