Unpacking Of Devices; Environment Conditions; General Installation Instructions; Servicing - Barco P110 Hardware Reference User Manual

Barco P110
This product is intended for professional use only.
It is not intended for household use!

1.3.3 Unpacking of devices

For unpacking, follow the instructions and advice indicated on the outside of the packaging!

1.3.4 Environment conditions

The table below specifies the environment conditions in which the product may be safely operated or stored.
Environment
Ambient temperature
Humidity
Altitude
The product must be stored and transported in the original packaging in accordance with
the non-operating conditions specified above.

1.3.5 General installation instructions

•
Do not place this unit on an unstable cart, stand, or table. The unit may fall, causing serious damage to it.
•
Do not use this unit near water.
•
Do not use any power cords other than the one supplied with your unit. While appearing to be similar,
other power cords have not been safety tested at the factory and must not be used to power the unit. For
a replacement power cord, contact your dealer.
•
Slots and openings in the cabinet and the sides are provided for ventilation; to ensure reliable operation of
the unit and to protect it from overheating, these openings must not be blocked or covered. The open-
ings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This
product should never be placed near or over a radiator or heat register. This unit should not be placed in
a built-in installation or enclosure unless proper ventilation is provided.
•
The maximum recommended ambient temperature for this equipment is 40 C.
•
When using the unit in a multi-unit rack assembly or closed assembly, the ambient temperature inside the
assembly may not exceed the maximum rated ambient temperature.
•
When installed in a rack, the installation should be such that the amount of air flow required for safe op-
eration of the equipment is not compromised. The mounting of the equipment should be such that no
hazardous condition is achieved due to uneven mechanical loading.

1.3.6 Servicing

P110 does not require any servicing or regular maintenance work other than vacuuming the air vents in the
housing rear and front at regular intervals.

1.3.7 Cleaning

Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners.
P 4
Hardware Reference User Manual - P110, Document No. R591686_01
www.barco.com
Operating
0 to 40 deg C / 32 to 104 deg F
5% to 80% non-condensing
-60 to 5,000 m / -197 to 6,562 ft
Non-Operating
-20 to 60 deg C / -4 to 150 deg F
5% to 95% non-condensing
-60 to 10,000 m / -197 to 32,808 ft
Preface