Table of Contents
Advertisement
Instruction manual | PS220 Mobile Energy Storage
Why does PS220 not charge?
• Make sure, that if you are charging from a wall outlet you are using the charger provided.
• Make sure, that if you use a solar panel that it is 15~18VDC type and no more than 80W capacity.
• Make sure, that if you are charging from a car or boat that the engine is running during charging.
Why does PS220 not automatically recharge if you accidentally disconnect and then reconnect again
immediately?
• Make sure, that you are using the correct charger.
• If the current or voltage is too high, PS220 will engage its automatic protection feature.
• Disconnect charger and restart, it should function normally.
Why does the screen turn off when the PS220 is fully charged?
PS220 automatically turns the screen off to save power. Restart the PS220 and the screen should turn on.
Why will the PS220 not turn on when DC Button is pressed?
The battery voltage may be too low. Charge PS220 by adapter through DC input port.
Why is there no output from the "DC Output" after turn on, when PS220 has been operating nor-
mally?
Confirm that the load does not exceed the 12V/5A rating. If the load rate is more than 5A, the Power Pack's
automatic protection feature will activate. Reset your Power Pack and it should then function normally.
How long will the PS220 run or recharge my device?
Here are some common devices and their watt-hour requirements.
Device
5W LED Light
Smartphones (5,5 Wh)
Laptop (60 Wh)
Tablet (33 Wh)
Drone (68 Wh)
When you're deciding on what to power from your PS220 recharge, do some research into your device's wat-
tage consumption.
The approx. values were determined with an ambient temperature of 25°C and fully charged battery.
These values may vary, depending on the manufacturer of the electric device, unit, etc.
NOTE
The above data are to be used only as reference points.
Lithium
Power from
PS220-ion
~43 hours
~39 recharges
~3,5 recharges
~6,5 recharges
~3 recharges
13
Advertisement
Table of Contents
