Operation - Kenmore 437.83163 Owner's Manual

SET-UP
Visually.inspect the HEPA Air Cleaner upon
removing the unit from its box. Remove and
discard any packaging material. Return the
unit if it shows any signs of damage or
mishandling. This unit was thoroughly
inspected and tested-at the factory prior to
packaging.
o
ELECTRICAL HOOK=UP
Plug the air cleaner into a polarized 120 Volt
AC. wall outlet.
'6/AR N ! N G
To avoid fire or shock hazard, the
HEPA air cleaner should "o_ly be
plugged into a polarized 120 Volt
AC. outlet.
OPERATION
Adjust the power/control switch to the desired
output setting"
=SUPER ,. Fast initial cleaning
HIGH - Daytime operation-- fast fan speed
LOW - Night-time quieter operation
Turn IONIZER switch ON.
CAUTI 0 N
Never operate the, _.
HEPA air cleaner without the HEPA
filterproperly installed, permanent motor
damage could result.
FILTER CARTRIDGE REPLACEMENT
Step 1
Tumthe HEPA Air Cleaner OFF and unplug
the unit from the power outlet.
Step 2
To open, gently place the air cleaner on it's
side. Unscrew the LOCKING HANDLE to
release the BASE from the air cleaner,
LOCKINGKNOB
1
BASE
CLEANING
Step 3
NOTE: PRIOR TO ANY CLEANING
OPERATION, THE HEPA AIR CLEANER
MUST BE TURNED OFF AND UNPLUGGED
FROM THE POWER OUTLET.
Remove the
cleaner.
BASE assembly from the air
Steps 4, 6 & 6 - Replacing the carbon
Impregnated lore-filter (item #433166).
Clean the HEPA air cleaner's external surfaces Step 4
with a moistened soft cloth only. Do Not"
Directly Wet With Water Or Any Abrasive .Remove the Filter Assembly (consisting of
Type Cleaner. Clean all external surfaces, the HEPA filter and pre filter) from the Power
especially the Air Intake and Exit grills. Head. - ,.:
. , ,