Program 4.0: Unit Configuration; P4.1: Ready Indicator And Auto Endpoint Function - Accumet AP75 Operating Instructions Manual

P4.0: Unit configuration
7.5

P4.1: READY indicator and auto endpoint function

Program P4.1 lets you select "READY indicator on" to indicate when your measure-
ment is stable, or select "READY indicator off" for faster meter response.
Program P4.1 also lets you switch the Auto endpoint function on or off. Select auto
endpoint on to "hold" your measurement when it is stable for more than 5 seconds.
The display automatically freezes, and the HOLD indicator appears on the left side
of the display. Press the HOLD key to release the display and access other functions.
Select auto endpoint off to deactivate this feature.
From measurement mode
1.
Press Setup key to enter Set Up mode.
2.
Press the and
subgroups until you view parameter P4.0.
A
See figure
3.
Press the ENTER key to select
parameter 4.1.
See figure
B
4.
Press the and
configuration you require.
• OFF switches the READY indicator off.
• ON switches the READY indicator on.
• ON and HOLD together switches the
auto endpoint feature on.
5.
Press the ENTER key to confirm selection
and to proceed to step 4 of P.4.2. Press the
CAL/MEAS key to return to measurement
mode.
Notes
Meter default is set for Ready indicator on,
and auto endpoint function off.
keys to scroll through
keys to select the
A
B
31