Advertisement
FULLONE
YEAR WARRANTY
ON CRAFTSMAN
BELT AND DISC SANDER
If with In one year from the data of purchase, th Is Craftsman BeIt and Disc Sander fails due to a defect in mater lal
or workmanship, Sears will repair it, free of charge.
WARRANTY SERVICE IS AVAILABLE
BY SIMPLY CONTACTING
THE NEAREST SEARS SERVICE CENTER/
DEPARTMENT THROUGHOUT
THE UNITED STATES.
THIS WARRANTY
APPLIES ONLY WHILE THIS PRODUCT IS USED iN THE UNITED STATES.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
SEARS, ROEBUCK AND CO., 698/731A, Sears Tower, Chicago, IL 60684
safety
Safety is a combination of common sense, staying alert
and knowing how your belt and disc sander works. Read
this manual to understand this sander.
instructions for beUtand
isc sander
BEFORE USING THE SANDER
WARNING:
To avoid mistakes that could cause
serious, permanent injury, do ROtplug the sander in
until the following steps are completed.
WHEN
INSTALLING
OR MOVING
THE
SANDER
AVOID DANGEROUS ENVIRONMENT.
Usethesander
in a dry, indoor place protected from rain.
Keep work
area well lighted.
Place the sander so neither the user nor bystanders are
forced to stand in line with the abrasive belt or disc,
Assembly and alignment.
(See pages 7 - 11)
To avoid injury from unexpected sander movement:
Learn the use and function of the ON-OFF switch,
backstop, belt tracking knob, belt tension lever, work
table and worktable tilt lock knob. (See pages 12-13)
Review and understanding of all safety instructions
and operating procedures in this manual.
• Review of the maintenance methods for this sander.
(See pages 19 - 20)
Read the following WARNING label found on the front of
the sander:
Always unplug the sander before moving it.
Put the sander on a firm level surface where there is
plenty of room for handling and properly supporting
the workpiece
• Support the sander so it does not rock.
Bolt the sander to its work surface. Use the fasteners
and method shown in "Assembly and Alignment."
• (Page 7)
NEVER STAND ON TOOL.
Serious injury could
occur if the tool tips. Do not store anything above or
near the tool where anyone might stand on the tool to
reach them.
To avoid injury or death from electrical shock:
• GROUND THE SANDER.
This sander has an ap-
proved 3-conductor cord and a 3-prong grounding
type plug.
Use only 3-wire, grounded outlets rated
120 volts, 15 amperes (amps). The green conductor
in the cord is the grounding wire. To avoid electrocu-
tion, N EVER connect the green wire to a live terminal.
Make sure your fingers do not touch the plug's metal
prongs when plugging or unplugging the sander,
Advertisement
