Con Guring Computer For Connection - DiGidot C4 Quick Start Up Manual

Con guring computer for
connection
Before you can start working with the User Interface
of the DiGidot C4 you should re-configure your
computer's LAN settings. Note that changing your
Ethernet settings will block your LAN network
connection. If you wish to be connected to the
Internet and using the DiGidot C4, then it is best to
have a computer that has both LAN and Wi-fi
connection. By accessing the User Interface of the
DiGidot C4 you can change the settings, so it fits with
the Art-Net control Software/Device and the type of
LED.
For PC
Go to
Control Panel - Network and Sharing Center - Ethernet
- Properties - Internet Protocol Version 4 (TCP/IPv4) -
Use the following IP address
Then replace the IP settings in the following boxes to:
IP adress: 10.0.0.1
Subnet mask: 255.0.0.0
For Mac
Go to
System Preferences - Network - Ethernet - Configure
IPv4 - Manual
Then replace the IP settings in the following boxes to:
IP address: 10.0.0.1
Subent mask: 255.0.0.0
8