Table of Contents
Advertisement
SETTING AND USING METHOD
38
!
CAUTION
• According to watt-hour meter/gas meter and PDI installation time, the final accumulated
value displayed by each may be different.
• During the ACP/Smart interface, if you set the e-mail, e-mail alarm is sent when wattage
and gas usage amount distribution cannot be made by special conditions.
• PDI accumulated power value and accumulated gas usage value are not initialized.
• When you change the indoor unit address, you can check the accumulated power amount
(gas usage amount) of each indoor unit address that is not set to each port in ACCUM(ALL)
screen.
Error display
If the communication with the air conditioner is not smooth or if the pulse signal is not detected
from the wattmeter, the error will be displayed on the LCD.
• Communication error display
- If there is no communication with the indoor unit product for 3 minutes, it displays an error.
- During communication error status, power consumption (gas consumption) is reflected on the
accumulative power (accumulative gas).
- No power(gas) is distributed to each indoor unit. When communication is resumed, accumula-
tive power (gas) is distributed to each indoor unit.
E R R O R - 0 1
N O
C O M M U N I C A T I O N
W I T H
A I R C O N D I T I O N E R
I D U
A D D R E S S
• No signal error in the wattmeter (gas meter)
- Error is displayed when there is no signal from the pulse detection in the option-set wattmeter
(gas meter) (When no pulse is detected even when 1 or more unit doors are operating)
E R R O R - 0 2
N O
S I G N A L
F R O M
!
CAUTION
• In the case of no signal error in the wattmeter (gas meter)
As outdoor unit power consumption (gas consumption) is low, if no pulse is displayed for a
certain time, error may be displayed. As soon as pulse is applied, error indication disap-
pears.
[ 0 0 - 0 7 ]
W H M 1
Advertisement
Table of Contents
