LG PPWRDB000 Installation And Owner's Manual page 34

SETTING AND USING METHOD
34
• Checking accumulative power
Accumulative power: After the power is initially connected to the power indicator, the values
are accumulated.
If the displayed electric energy is 999 999 or above, it will return to 0.
• Screen Description
A C C U M ( P 1 )
A D D R - 0 :
A D D R - 1 :
A D D R - 2 :
- Press the LEFT/RIGHT (◀,▶) button to increase/decrease the wattmeter number.
- Press the UP/DOWN (s,t) button to check the electric energy of all indoor units connected.
- In 1.3 or less version, each indoor unit number increases sequentially according to the set num-
ber of units.
- In 1.4 or higher version, it displays the address of the indoor unit set for each indoor unit number.
- If the standby power is set to MANUAL, the last page is displayed as follows.
A C C U M ( P 1 )
S T B P :
- In 1.4 or higher version, if you press left/right button(◀,▶), it is displayed as follows in the last
page. You can check the entire indoor units' accumulated power for each address in this screen.
A C C U M ( A L L )
A D D R - 0 :
A D D R - 1 :
A D D R - 2 :
! CAUTION
• According to watt-hour meter and PDI installation time, the final accumulated value dis-
played by each may be different.
• During the ACP/Smart interface, if you set the e-mail, e-mail alarm is sent when wattage
distribution cannot be made by special conditions.
• PDI accumulated power value is not initialized.
• When you change the indoor unit address, you can check the accumulated power amount
of each indoor unit address that is not set to each port in ACCUM(ALL) screen.
0 . 0 k W h
0 . 0 k W h
0 . 0 k W h
0 . 0 k W h
0 . 0 k W h
0 . 0 k W h
D O W N
0 . 0 k W h
0 . 0 k W h
0 . 0 k W h
Wattmeter number
Overall accumulated power
of P(1) wattmeter
Accumulated power of each
applicable indoor unit
Each indoor unit number