To Prevent The Screen Saver From Blanking The Screen After Several Minutes; To Enable Ir Remote Control Using Cec From Osmc; To Enable Ir Remote Control Using Lirc From Osmc; Monitoring The System Processes, Cpu Usage, And Memory - NEC C751Q Setup Manual

9.1.18 To prevent the screen saver from blanking the screen after several minutes

From the Raspbian edit the following file as sudo: /etc/lightdm/lightdm.conf
Modify the following section to add the highlighted text:
[SeatDefaults]
xserver-command=X -s 0 –dpms

9.1.19 To enable IR Remote control using CEC from OSMC

Navigate to: Settings  System  Input  Peripherals  CEC Adapter
Enable the setting. A restart may be required before the CEC device can be detected by the display.
Use the supported CEC buttons on the NEC IR Remote. See Figure 3.4-3.
See sections 0, 8.15 and 8.16 for more information.
Note: Information as of OSMC version 2017.02-2

9.1.20 To enable IR Remote control using lirc from OSMC

Navigate to: My OSMC  Remotes.
Scroll to the correct IR remote type or "lircd-full" and select.
Make sure that "Disable RC6" on the bottom right isn't selected.
Navigate to: My OSMC  Pi Config  Hardware support.
Select "Enable LIRC GPIO support".
The use the default of gpio_in_pin = 18.
A restart may be required before lirc can be started.
See section 0 and 8.5 for more information.
Note: Information as of OSMC version 2017.02-2

9.1.21 Monitoring the system processes, CPU usage, and memory

The htop system tool is an interactive system-monitor process-viewer and process-manager that gives
visual information about processor, swap and memory status. Run from the command or terminal window:
htop
©2018 NEC Display Solutions, Ltd.
Page 57 of 71