Operating Instructions - TensCare Perfect Beauty Instructions For Use Manual

10.2. OPERATING
INSTRUCTIONS
ON/OFF
To turn the unit ON, press the
ON/OFF button on the top of the unit
and hold for 3 to 5 seconds until the
display shows.
To turn the unit OFF, press the ON/OFF
button on the top of the unit and hold for
3 to 5 seconds until the display stops
The unit will turn OFF automatically:
When the Timer reaches zero,
If it is left at zero strength for more than
5 minutes.
The unit will start with the programme
you used last.
At first use, or after changing batteries,
the display shows that the unit is
automatically set in programme FACE
1 at zero strength.
Note: Always check unit is OFF
before applying or removing
electrode pads.
The backlight will turn off 10 seconds
after the last button press.
On the front of the unit there are six
buttons:
STRENGTH CONTROLS
The buttons marked CH1+, CH1-,
CH2+, CH2- are the strength controls.
The left-hand buttons
CH1+
change strength in the
left-hand lead, CH1,
and the
CH1-
buttons change the
right-hand lead, CH2.
CH2+
right-hand
CH2-
23
To increase strength in steps of 1 mA,
press and release the top part of the
channel buttons, CH1+ and CH2+.
The strength levels are shown on the
LCD.
The strength control buttons will not
operate until the unit is properly
connected to you. If the perfect
BEAUTY detects a disconnection in
either channel it will automatically
return the strength to zero in that
channel and flash '00'.
The unit has 90 levels of strength
except for the facial programmes
(FACE 1 and FACE 2), which only go
up to 40 mA (40 steps).
If you hold down the strength controls
for 3 to 5 seconds, the strength will start
increasing continuously.
You may feel nothing over the first few
presses. Continue pressing until the
sensation is strong but comfortable. At
each phase of the programme the
intensity automatically adjusts to give a
comfortable stimulation,
further increases during use may be
necessary if your body becomes used
to the sensation. To decrease the
strength, press and release the lower
part of the buttons marked CH1- and
CH2-.
The yellow LED on the output socket
indicates that there is an active output
which can be high enough to be harmful
if not used correctly. The display will
remain on for 5 seconds after the plug
is removed.
PROGRAMME CONTROL
The button marked P is the
P
programme
however
control. The