Assembly; Fence; Fence Extension - Sears 149.23632 Owner's Manual

5. Place square against face of fence and table surface. Bring
fence square to table and tighten lock knobs.
6. THERE MUST BE 1/32" TO 1/16" gap between the lower edge
of the fence and jointer tables (with table set for 0" cut). To
adjust, move fence assembly by loosening the 1/4-20 x 314
hex cap screws attaching the fence brackets to the base.
Retighten hex cap screws after adjustment has been made.
7. Recheck squareness of fence.
8. Install tilt indicators with #10-24 x 1/2 pan head machine
screw and #10 flat washers. Set 0 ° of indicators to 0 ° of
segments, and tighten the screw.
9. The fence should now be adjusted and will accurately measure
angles to 45 ° inboard and 45 ° outboard (see adjustments
section).
TILT INDICATOR SHOULD BE LINED UP WITH
FENCE SEGMENT AT THE O'MARK.
DO NOT OVER TIGHTEN
FENCE EXTENSION
To aid in edge jointing of workpieces 4" and wider, you may
extend the fence height. The extension can be constructed of
1" (3/4" thick) stock pine or hardwood.
Use #8 flat head wood screws of sufficient length to securely
attach the extension to the fence. Make sure that the head of the
screws are below the surface of the fence so as not to interfere
with the workpiece.
For extra stability, additional countersunk holes have been pro-
vided near the ends of the fence.
_C
1/4_
A
4,8 FLATHEAD _
COUNTERSUNK SCREWS _-'-
j'rll___
FENCEJ
q
i
BI
._I____ 114
,-- E OPTIONAL
,/ FOR EXTRA STABILITY
_____ _ O OPTIONAL
-<_- FOR EXTRA STABILITY
L
--- -,,-- 1/2
A
A= 11/16 Thick x 2" Wide x 10" Long
The 11/16 thickness can be obtained by planing the board on
the jointer-planer.
B= 112" to 314" Thick x 3-1/2" Wide x 10" Long
This piece may also be made out of plywood.
C= 314" Thick x 2-1/2" Wide x 19-1/2" Long
The 2-112" width may be increased if desired.
OPTIONAL -- For Extra Stability
D= 11/16" Thick x 2" Wide x 2" Long, 2 Pieces
E= 1/2" to 314" Thick x 3-1/2" Wide x 2" + Long, 2 Pcs.
NOTE: Cut both D pieces from the same stock or thickness as
board A and cut both E pieces from the same stock or thickness
as board B.