Advertisement
SUPPORT
POST
f
RETAINER
SPRING
REAR
MOUNTING
BRACKET
FIGURE 10
SUPPORT
BRACKET
PIN
SUPPORT
POST
ELBOW
I
5116 HEX
BOLTS
FORMED WAI
ELBOW
I
SUPPORT
TUBE
END PLUG
_" _
ELBOW SHIELD
_"_
LOCKNUTS
FIGURE
11
5. Assemble
the support post to the rear mounting
bracket (Fig. 10) using support bracket pin and re-
tainer spring. Retainer spring shown furl size below.
Support post, latch pin and retainer spring furnish-
ed with bagger.
6. Mount elbow support tube to support post (Fig. 1 1)
using: two 5/16 hex bolts and two 5/16 Iocknuts
{shown full size below}. NOTE: Position elbow sup-
port tube as shown in Fig. 1 1, Tighten securely,
Elbow support
tube and hardware
furnished
with
bagger.
©
7. Install end plug (Fig. 1 !) on elbow support tube. End
plug furnished
with bagger.
8. Mount the elbow retainer and the elbow shield to
the elbow support tube (Fig. 1 1) using: two form-
ed washers and two 5/16 Iocknuts {shown full size
below).
NOTE: Do not tighten.
Elbow
retainer,
elbow shield and hardware
furnished with bagger.
©
.
Slide elbow through elbow'retainer
(Fig. t2 - Inset).
Secure elbow to elbow retainer using: two clips,
two screws,
two washers
and two acorn nuts.
NOTE: Mount clips in holes located 2 - I/2"
from
edge of elbow. Hardware
shown full size below,
Heads of screws and flat washers mount to the in-
side of elbow. Position clips with closed end of clip
facing tube opening as shown in Fig. 12 - Inset.
Tighten
securely.
NOTE:
Tighten
hardware
assembled in step 8. Elbow and hardware furnish-
ed with grass catcher.
10.
Flip seat
forward.
1111111111111111111]
Q
-8-
Advertisement
