Advertisement
CHECK FOR DAmAGED PARTS. Before using this product, carefully check that it
8.
will operate properly and perform its intended function. Check for damaged parts and
any other conditions that may affect its operation. Replace or repair damaged or worn
parts immediately.
9.
mAINTAIN PRODUCT WITH CARE. Keep this product clean and dry, and moving parts
lightly lubricated for better performance. Keep the Handle dry, clean and free from oil,
grease, and solvents.
10.
USE THE RIGHT PRODUCT FOR THE RIGHT JOB. Do not attempt to force a small
tool or attachment to do the work of a larger industrial tool. There are certain applications
for which this tool was designed. It will do the job better and more safely at the rate
for which it was intended. Do not modify this tool and do not use this tool for any
purpose other than which it was intended. Use for intended purpose only.
When unpacking, check to make sure all parts shown on the Parts Illustration (page 6) are includ-
ed. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on
the cover of this manual as soon as possible.
NOTE: Please refer to the parts listed on page 7 of this manual. Use 3/16" diameter bolts
of the appropriate length when mounting your Vise. Bolts, Lock Washers and Nuts for mount-
ing are NOT provided. You can mount the Vise or use it in a portable manner, depending
on what product you are working on.
1.
Use the two mounting holes on the Vise Back Jaw with Clamp (1) as a template. Set the
Vise flat on the workbench and, with a pencil, mark the points at which to fasten the Vise
onto the workbench. Set the Vise aside.
2.
Drill two holes of the appropriate size (where previously marked with a pencil) through
the top of the workbench. Caution: Before drilling holes, check for hidden electrical
wires or cords in drilling path.
3.
Carefully set the Back Jaw (1) of the Vise with the two Mounting Holes corresponding
to the holes previously drilled through the top of the workbench. See Figure 1 next
page.
4.
Insert two 1/4" diameter hardened steel bolts (not provided), of the appropriate
length, downward through the Back Jaw (1) and the drilled holes in the workbench.
The length of hardened steel mounting bolts will vary, depending on the thickness of
workbench the Vise is to be attached to.
SKU 95203
UNPACKING
mOUNTING THE CARPENTER'S VISE
For technical questions please call 1-800-444-3353.
Page 3
Advertisement
