Remote Control - Sanyo CZP 2515V Instruction Manual

Remote Control Operation
I
1
Main ON/OFF switch of the TV set must be in "ON" position before remote
control operation impossible.
Point transmitter towards the TV set, then press the appropriate function button
for the following controls.
. The keys on the Remote Control Transmitter operate in the same manner as
those on the front of the television. In addition to those controls, the transmit-
ter has these additional functions: Programme Selection (direct selection),
NORMALIZATION, Sound Mute, OFF TIMER, Alternate, RECALL and
FINE TUNING.
~.... Power ON/OFF ~
Press this button to switch TV set on. To switch TV set off, press again.
Note: The red standby indicator @ will remain illuminated when the TV set
is switched off with this button. This is to indicate that the TV set is
still partially energized.
To disconnect TV set completely from mains, switch off with Main ON/OFF
switch on the T.V. set itself.
~.... Programme selection
. For selection of the programme number 1 to 9, press the programme selec-
tor button-.
For selection
of the programme number 10 to 19 or 20 to 29, press the "l-"
or "2-" button and then press the "O" to "9" programme selector button
~ within five seconds.
@ .. . . VCR Position Selector (This button serves as a Programme Selector, too.)
When using a VCR connected to the aerial socket, VCR Position must be
selected by pressing this button.
. Each time the VCR Position Selector @ is pressed, the VCR Position
number will change as follows:
VCR1 —VCR2 —VCR3
. The character of "VCRI", " VC~2~
~ "VCR3" is displayed on the screen.