Sanyo CZP 2515V Instruction Manual page 7

Pre-Setting of Stations
Up to 32 broadcast stations in your reception area
can be stored in the electronic memory.
~ Set the ~ MODE switch to ON position.
~ Select the programme number (with programme selector button@ or ~) for which
you would like to preset a program.
Set the ~ BAND SWITCH to the channel band corresponding to your desired
channel.
Channel band VL, VH and U are for the following channel groups.
VHF range
Band VL(I) Channels 1 – 3
Band VH(IU)
Channels 4 – 11
UHF range
Band U Channels 21 – 69
The channel (VL, VH or U) Band is displayed on screen.
REMARKS
When the band is set using the BAND SWITCH, the frequency will be set to the lowest
frequency in the set band.
~ Press and hold the @ (+) SEARCH button to station searching.
When a station is found, release the (+) SEARCH button as soon as picture appears.
REMARKS
The lowest bar display changes according to UP/DOWN of tuning voltage.
If the station found in above step is not the one to be set, press the (+) SEARCH BUTTON
again until the desired station appears.
~ Once the best picture have been obtained, press the ~ MEMORY button to store the
station located by the tuning in the electronic memory.
~ Repeat steps – for remaining program numbers to be set.
~Be sure the O MODE switch is in OFF position.
When the MODE switch is switched OFF, BAND SWITCH, the (+) and (–) SEARCH
buttons will not function.
Memory Copy
This T.V. tuning system has another advanced feature called'''memory copy".
A station entered into the memory at a particular programme number can also be received
at any other programme number, to use this feature follow the procedure below.
If you wish to copy the T.V. channel in the programme number "2" into the programme
number "1 5".
1. Select the programme number "2". (with the prog. selector @or ~.)
2. Turn the MODE switch @ ON.
3. Select the programme number "15". (with the prog. selector @or ~.)
4. Press the MEMORY button ~, set the MODE switch @to OFF.
–6–