Advertisement
digital audio
modular
processing system
DANTE INTERFACE
Product Type
Product Version
Module
Module Software
Module MB App
RESET
Restart Module
Initialize and Restore
Factory Defaults
BACKUP / RESTORE
Backup Settings and
Presets to File
Restore Settings and
Presets from File
SETUP:
Set up of general device parameters
Common Config
Enable Bus Driver
C8000
64ch BNC MADI & AoIP I/O
[c8k_x]
Customized version for the c8k system
[x.y.z]
HW of the DANTE OEM module
[Brooklin II]
DANTE OEM module
[3.10.0]
Software version of the module FPGA
[1.1.5]
Software version of the FPGA embedded controller
<RESTART>
Pressing the soft button will warm start the module.
<INITIALIZE>
Pressing the soft button, will clear the parameter memory and
will initialize all parameters to their factory default values.
<BACKUP>
Pressing the soft button will create an XML file that one may
store on a PC.
<RESTORE> l
Pressing the soft button will upload a backup file that has been
selected via soft button <BROWSE> and move the previously
stored settings back to the module.
[ON/OFF]
You can temporarily disable the bus drivers by selecting OFF here.
The state of this soft switch also depends on the setting of SW1 on
the module PCB.
If SW1 #1 is turned off, this switch will be off after a power cycle.
You can turn it on temporarily to check out your settings but you
must keep in mind that after the next power cycle it will be off again
unless you have turned SW1 #1 on.
This procedure is useful if you must insert a module into a frame
that is on air and other services must not be interrupted or
disturbed.
C8315
9/20
Advertisement
