Advertisement
digital audio
modular
processing system
Enable BUS Driver
AoIP
RX
To C8000 System Bus
2Ch Mode
Bus
8ch TDM Mode
Bus
Channel
MADI
RX
To C8000 System Bus
2Ch Mode
Bus
8ch TDM Mode
Bus
Channel
C8000
64ch BNC MADI & AoIP I/O
[ON / OFF]
You can disable the output drivers by un-checking the
Enable Bus Driver check box. The state of this check box also
depends on the setting of SW2 on the module PCB.
If SW2 #1 is turned off, this checkbox will be off after a power
cycle. You can turn it on temporarily to check out your settings but
you must keep in mind that after the next power cycle it will be off
again unless you have turned SW2 #1 on.
This procedure is useful if you must insert a module into a frame
that is on air and other services must not be interrupted or
disturbed.
[CH1/2 ... Ch63/64 ... --]
One of the 32 channel pairs provided by the AoIP interface.
[S1 ... S32 ... --]
One of the 32 bus lines of the c8k back plane. Two audio channels
are put onto one bus line.
Eight channel mux mode
[S1 ... S32 ... --]
One of the 32 bus lines of the c8k back plane. Eight audio channels
will be muxed onto one bus line.
[Ch1/2 ... Ch7/8]
A pair from the eight multiplexed channels.
[CH1/2 ... Ch63/64 ... --]
[S1 ... S32 ... --]
One of the 32 bus lines of the c8k back plane. Two audio channels
are put onto one bus line.
Eight channel mux mode
[S1 ... S32 ... --]
One of the 32 bus lines of the c8k back plane. Eight audio channels
may be muxed onto one bus line.
[Ch1/2 ... Ch7/8]
A pair from the eight multiplexed channels.
C8315
18/20
Advertisement
