Emergency Factory Default - Elan EL-IP-OBF2-WH Quick Start Manual

EMERGENCY FACTORY DEFAULT

To restore the hardware to factory default settings, please follow these steps:
1. Press and hold RESET for 10 seconds before releasing.
2. The camera will be restored to factory default settings after approximately
90 seconds and will reboot automatically.
3. Search for the IP device using the IPScan software.
4. Start the IP device via an Internet browser.
5. Enter the default username "ELAN" and password "3526" to operate.
NOTE:
Cameras are configured to use DHCP by default but will revert to the
default address 192.168.0.200 if a DHCP server is not available.
BEFORE ACCESSING IP CAMERAS
Before accessing the IP camera, make sure that the camera's RJ-45 network,
audio, and power cables are properly connected. To set the IP address,
consult your network administrator for an available IP address. The default IP
address for each IP camera is 192.168.0.200. Users can use the default IP
address to verify the camera's network connection.
contact techsupport@elanhomesystems.com
EL-IP-OBF2-WH / EL-IP-OBF4-WH / EL-IP-OBV2-WH / EL-IP-OBV4-WH
9