Operation; Vacuuming Dry Materials - Craftsman 125.16829 Operator's Manual

Operation

Vacuuming Dry Materials

WARNING: Be sure to read, understand and apply all the information in the
Important Safety Instructions section at the beginning of this operator's manual.
Do not vacuum in areas with flammable gases, vapors, or explosive dusts in the
air. Flammable gases or vapors include but are not limited to: lighter fluid,
solvent type cleaners, oil-base paints, gasoline, alcohol, or aerosol sprays.
Explosive dusts include but are not limited to: coal, magnesium, grain, or gun
powder. To reduce the risk of health hazards from vapors or dust, do not
vacuum toxic materials.
WARNING: Before any Wet/Dry vac assembly or disassembly make sure that
the power cord is not plugged into a power outlet.
1
6
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. For dry vacuuming, the included
cloth filter must be installed correctly.
To verify, refer to Installing Reusable
Cloth Filter on page 10.
3. Place the power head back on the
container, and secure it in place
using the clasps. (Fig. 2)
4. Insert the large end of the hose into
the vacuum port and fit it securely
into place. (Fig. 3)
5. Choose the desired accessory and
insert onto the attachment end of
the hose. (Fig. 4)
6. Verify that the On/Off switch is in the
Off position. Plug the power cord
into the outlet. (Fig. 5)
2 3 4
7. Turn the motor on by pressing the
power switch to the 'I' (ON) position
and begin vacuuming. (Fig. 6)
8. Once you have completed
vacuuming, press the power switch
to the 'O' (OFF) position and unplug
the power cord from the outlet.
O = OFF
DO NOT USE THE REUSABLE CLOTH
FILTER FOR LIQUID VACUUMING.
CAUTION: Do not vacuum drywall dust,
fireplace soot or ash with standard
filter. This is very fine dust which will
not be captured by the filter and may
cause damage to motor.
7
5
I = ON