Maintenance; Emptying The Collection Tank; Installing & Cleaning Reusable Cloth Filter - Craftsman 125.16829 Operator's Manual

Maintenance

Emptying the Collection Tank

1
2
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Disconnect the hose from the
vacuum. (Fig. 2)
3. Undo the clasps and remove the
power head from the collection tank.
(Fig. 3)
4. Clear all dirt or debris from the
collection tank and hose. (Fig. 4)
5. Clean or replace the filters. (Fig. 5)
6. Check the hose, attachments, and
power cord to verify that they have
not been damaged.
Installing & Cleaning Reusable Cloth Filter
1 2
Installing Reusable Cloth Filter
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Remove power head and place in
the upside down position.
3. Slide reusable cloth filter down
over the filter cage making sure the
whole cage is covered. (Fig. 2 & 3)
4. Replace and lock the power head
onto the collection tank.
Removing and Cleaning Cloth Filter
1. Remove power head and place in
the upside down position.
3 4
NOTICE! The included cloth filter is to
be used for dry pick-up only. A dry filter
is necessary to pick up dust. If the dust
filter is wet, it will clog quickly and be
very difficult to clean. Handle the filter
carefully when removing it for cleaning
and replacing it. Check the filters for
tears or small holes; a small hole can
let dust pass through and out of the
cleaner. Do not use a filter with holes or
tears; replace it immediately.
4
3
2. Carefully remove the reusable cloth
filter from the filter cage. (Fig. 4)
Clean the filter by gently tapping or
brushing dirt off. Cleaning should
not be done indoors in living areas.
3. After multiple uses, the filter can
become dirty with accumulated
dust. Use a mild soap and water
solution to wash reusable cloth filter
and rinse with clean water. (Fig. 5)
4. Allow the wet filter to air dry for 24
hours before installing onto the filter
cage.
10
5
5