Download Print this page

Snapper GT600 Series Operator's Manual page 28

Hydro tractor & mower deck, mower deck
Hide thumbs Also See for GT600 Series:

Advertisement

Battery Charging
WaRNING
Keep open flames and sparks away from the
battery; the gasses coming from it are highly
explosive. Ventilate the battery well during
charging.
A dead battery or one too weak to start the engine may be
the result of a defect in the charging system or other elec-
trical component. If there is any doubt about the cause of
the problem, see your dealer. If you need to replace the
battery, see the Clean the Battery and Cables section.
To charge the battery, follow the instructions provided by
the battery charger manufacturer as well as all warnings
included in the Operator Safety section of this manual.
Charge the battery until fully charged. Do not charge at a
rate higher than 10 amps.
Seat adjustment
The seat can be adjusted forward and back. Move the
lever (A, Figure 21), position the seat as desired, and
release the lever to lock the seat into position.
en
Check Mower Blade Stopping Time
The mower should come to a complete stop within five
seconds after PTO switch is turned off.
1. With tractor in neutral, PTO disengaged and operator
in seat, start the engine. Make sure the area is clear
of bystanders.
2. Engage the PTO and wait several seconds.
Disengage the PTO and check the amount of time it
takes for the mower to stop.
3. If the mower does not stop within five seconds, see
your dealer.
a
Figure 21. Seat adjustment
29

Hide quick links:

Advertisement

loading