Advertisement
Installation and Configuration HyperTerminal
HyperTerminal or an equivalent terminal emulator program is needed to display data from the Wireless BAS gateway and for
configuration of certain parameters
HyperTerminal is included with Windows XP and earlier versions and no installation is required. Windows Vista and Windows 7
users can download HyperTerminal from the following link http://www.idealwirelesssensors.com/files/HyperTerminal.zip
The download file is also found on the following page: http://www.idealwirelesssensors.com/support/
There are only two files in this ZIP package:
hypertrm.dll
hypertrm.exe
1. Unzip the files to a location of your choice and be sure to keep these files in the same directory. Do not launch
HyperTerminal until after the USB driver has been installed. This appendix describes how to configure HyperTerminal,
but the following settings are needed with any terminal emulator that is used:
Baud rate:
19200 bps
Data bits:
8 bits
Parity:
None
Stop bits:
1 bit
Flow control: None
Emulation:
ANSI or Auto Detect
Windows XP or Windows 2000
HyperTerminal is provided with Windows XP and earlier versions. To access the program use the following menu options:
Start Menu > All Programs > Accessories > Communications > HyperTerminal
Windows Vista or Windows 7
Go to the directory where HyperTerminal was installed from and double click on hypertrm.exe to launch the program.
2. Upon starting the program the dialog box may ask you if you would like to make HyperTerminal your default telnet
program. Select Yes or No to proceed.
- 5 -
Users Guide
Advertisement
