Advertisement
STATUS Descriptions
Address
31101
COMM_CHANNEL
31102
31103
ACTIVE_SENSORS
31104
SENSORS_WITH_LOW_BATTERY
31105
31106
TIMEOUT_CONFIG
31107
SENSORS_IN_TIMEOUT
31108
SOFTWARE_VERSION
31109
31110
SNMP Object Definitions – MIB File
Object Identifier
STATUS
COMM_CHANNEL
COMM_NET_ID
ACTIVE_SENSORS
SENSORS_WITH_LOW_BATTERY
REPEATER_MODE
TIMEOUT_CONFIG
SENSORS_IN_TIMEOUT
SOFTWARE_VERSION
Data Arrays
PWR
DELTA_T
S1
S2
S3
S4
S5
S6
S7
S8
TXID
Note – Each data array contains points, all labeled "node_XXX" where XXX is a number from 001 to 100, representing every sensor
available in the system. All array points are available regardless of whether or not they are active in the system. Each data array is
configured for up to 8 sensor inputs per device.
Status
COMM_NET_ID
REPEATER_MODE
RESERVED
RESERVED
Description
Communication channel of system
Communication network ID of system
Number of sensors active in system
Number of sensors that are sending a low battery signal
"1" means gateway is set as a repeater
Value (minutes) of timeout setting; mode disabled if "0"
Number of sensors currently in tiemout, if mode enabled
Version of gateway software
Description
Array containing the below info
Communication channel of system
Communication network ID of system
Number of sensors active in system
Number of sensors that are sending a low battery signal
"1" means gateway is set as a repeater
Value (minutes) of timeout setting; mode disabled if "0"
Number of sensors currently in timeout, if mode enabled
Version of gateway software
Battery voltage, or RSSI of RF powered sensors
Time (seconds) since the last packet was received
Sensor input 1
Sensor input 2
Sensor input 3
Sensor input 4
Sensor input 5
Sensor input 6
Sensor input 7
Sensor input 8
Transmitter ID (only valid in RF powered sensors)
- 23 -
Users Guide
Advertisement
