Table of Contents
Advertisement
5.
Locate the RS232 and RS485 cabling from the POS
equipment.
6.
Insert the RS232 cable connector into the Multicable jack
labeled PORT 1.
7.
Insert the RS485 cable connector into the Multicable jack
labeled PORT 3.
Equipment Power Up
Before installing your Mobil Indoor Speedpass equipment, a
quality surge protector should be purchased to protect the
equipment from voltage surges. Ideally, the Mobil Indoor
Speedpass equipment and the POS equipment should have its own
dedicated AC power outlet. The surge protector is plugged into the
AC power outlet first. The Mobil Indoor Speedpass Power Supply
should then be plugged into the surge protector.
Use the following procedures to power up the Mobil Indoor
Speedpass unit:
1.
Insert the Power Cable connector into the Multicable jack
labeled POWER.
Warning:
6
Installation
When the Power Supply is plugged into the AC power
outlet, voltage is immediately available to the Mobil
Advertisement
Table of Contents
