Advertisement
1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the
emergency brake set.
2. You will need the following tools:
a. 13MM Socket
b. ¾" Socket and Wrench
c. 15MM socket and ratchet
3. Hardware Included:
a. 6 – ½" x 1" Bolts
b. 6 – ½" Nyloc Nuts
c. 12 – Washers
1. Remove factory Rear Bumper using a 15mm socket and ratchet.
2. If you purchased lights for the bumper, now is a good time to install them.
3. With the help of another person place your new bumper onto rear section of frame.
–
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ADD 2007-2014 Jeep JK venom
Summary of Contents for ADD 2007-2014 Jeep JK venom
- Page 1 – 1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the emergency brake set. 2. You will need the following tools: a. 13MM Socket b. ¾” Socket and Wrench c. 15MM socket and ratchet 3.
- Page 2 4. Using factory hardware you will bolt your New Venom bumper to the frame. ****You will be bolting into the threaded holes in the frame*** Align Bumper and tighten bolts. If you purchased the A.D.D. Venom Tire carrier, Steps 5 & 6 pertain to you. 5.
Need help?
Do you have a question about the 2007-2014 Jeep JK venom and is the answer not in the manual?
Questions and answers