Transmitting; Receiving; Scanning; Low Battery Warning - SAMCOM FPCN30A User Manual

as long as the MONI button has been hold down.

Transmitting

First of all, hold down the MONI button and listen for a while to confirm the channel you wanted is not busy, and then speak
normally to the microphone at the front of the transceiver, while holding down the PTT button. The transmission
indicator turns red when the PTT button is pressed. If you speaks too loud or with your mouth getting too close with the
microphone, it may distort the sound and reduce the signal clarity on the receiving side. Release the PTT button to listen
to the partner's voices.

Receiving

Release PTT key, transceiver enter the receiving mode, the status indicator lights green. Please adjust the volume
appropriately to achieve the best listening effect.

Scanning

This feature is designed to catch signals on all channels. Press the scan/call button (press and hold for less than 2 seconds),
the LED indicator flashes green, it will scan all the channels in the scan queue one by one in order. When a channel
receives a signal, the LED indicator will turn green for long. When the function is activated, the transceiver will check whether
there are calls on the channels that are set to be scanned. If a channel is tested to have signals on it, it will switch to
this channel in order to receive voices (which channels can be scanned is programmed and set by Users).

Low Battery Warning

Low battery warning happens at the time when the battery needs charging or replacement. If the battery is low, the
transceiver indicator light turns red and blinks, and a beep sound can be heard every 5 seconds. At this time, please
replace the battery.
Voice Operated Transmitting (VOX)
This feature is designed to trigger the transmitting of voice by voice itself. Users can choose to turn on or off the VOX
feature, and set the sensitivity of VOX through Meun. With this feature, transmitting operation is launched by the
voice you said without having to press the PTT button. The transmitting operation stops as soon as the end of the talk.
Call function
Hold down the scan/call button for 2 seconds, the transceiver will send out a specific sub-tone that your companion
transceiver will ring prompted a call.
Voice compression and expansion
( p g y )