Husky HD7481-B Use And Care Manual page 7

USB Operation aasdasdasdasd
□ Prior to connecting any USB accessory to the USB port of
this device, make sure the accessory is Off [
□ Using the interface cable included with the USB accessory
to be powered or charged, connect the accessory to the
USB port (A) on the device.
□ Press the USB port power switch (B) to the On [ – ]
position. (The device with built-in battery will start
charging automatically).
□ Turn On the accessory and use as normal.
Unit Battery Hand Generator Operation
□ Make sure device switches are in the Off position.
□ Place the unit in a dry, open, flat area with overhead cover.
□ Using either hand, securely grasp the device carrying
handle (A). With the free hand, securely grasp the hand
generator pull-handle (B).
□ To generate unit battery crank charging, firmly pull-up on
the hand generator pull-handle while holding down the
device. Allow the hand generator pull-handle cord to retract
back into the device housing, thereby completing one (1)
generator crank cycle.
□ Continue hand generator cranking cycles for a minimum
period of 3 minutes. Hand generator charge LED indicator
will be flashing during operation.
□ The device internal battery will achieve a charging level
adequate enough for one (1) vehicle battery boost charge.
NOTE: Do not exceed the hand generator pull-handle
maximum cord length of 30 inches.
NOTE: The device unit battery charge level will vary
pending the device battery status at time of crank charge.
User may have to continue unit hand generator crank
cycles until the device unit battery reaches the charge level
adequate for jump starting (battery boosting) a vehicle.
].
D C 1 2
S O C K
B
7
V
E T
Please contact 1-888-HD-HUSKY for further assistance.
B
A
A
HUSKYTOOLS.COM