Husky HD7481-B Use And Care Manual page 6

LED Light & Emergency Flasher Operation
□ To power On the LED light, press the push-button switch (A)
once and release.
□ To power Off, press the push-button switch once more
and release.
□ To power On the emergency flasher, press the push-button
switch (A) once and release.
□ To power Off, press the push-button switch once more
and release.
NOTE: LED light or emergency flasher functions operate in
sequence to each other. The mode will depend on the prior
(last) operating function selected. User may have to cycle
between modes in order to achieve the proper lighting function.
Power Inverter Operation
□ Prior to operating, make sure the 120 Volt AC accessory
switch and the inverter power switch (A) are in the
Off [ ] position.
□ Connect the 120 Volt AC accessory to the inverter
receptacle (B).
□ Press the inverter power switch to the On [ – ] position.
LED green indicated normal operation. LED red indicates
inverter malfunction (over temperature, over load, over
voltage & low voltage).
□ Power On and operate the 120 Volt AC device.
□ To power Off, first power Off the 120 Volt AC device then
press the inverter power switch to the Off [
CAUTION: Only operate the 120 Volt AC device and
inverter in a clear dry area.
CAUTION: Provided with integral protection against
overloads. Do not expose to rain. To prevent fire, do not
cover or obstruct ventilation openings. Do not mount in
zero-clearance compartment. Overheating may result.
Neutral floating. The output of this device is not sinusoidal.
It has a total harmonic distortion of 31 percent and
maximum single harmonic of 35 percent. This unit employs
components that tend to produce arcs or sparks – to
prevent fire or explosion, do not install in compartments
containing batteries or flammable materials.
For continued protection against risk of fire, or electric
shock, replace only with same type and rating of fuse.
] position.
6
V
D C 1 2
E T
S O C K
V
D C 1 2
E T
S O C K
A
A
B