EOS 60IR Assembly Instructions And Instructions

Ir controller

Advertisement

Assembly instructions and instructions
60IR
GB
29342888en/ - 48.06
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 60IR and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for EOS 60IR

  • Page 1 Assembly instructions and instructions 60IR 29342888en/ - 48.06...
  • Page 2: Table Of Contents

    Contents General Information ....................10 General Safety Precautions .................. 10 Assembly of the controller ..................11 Mounting the sensor ..................... 12 Electrical installations ..................12 Installation of the booth lighting ................12 Circuit diagram ..................... 13 Operation ......................14 Error displays ....................... 14 Guarantee ......................
  • Page 3: General Information

    Dear Customer, General Safety Precautions With this IR controller you have purchased l Ensure that the electrical installation a high quality electronic appliance is accomplished only by an authorized developed and produced in conformance electrician. with the latest standards and quality l Observe the regulations of our guidelines.
  • Page 4: Assembly Of The Controller

    l The controller is sunk partly in the 1. Assembly of the controller booth wall. To this end, a right-angled l The controller is pre-installed for the opening of 120 x 170 (height x width) electrical connection. must be inserted in the tongued l The silicon connection cable for the grooved and beaded timbers .
  • Page 5: Mounting The Sensor

    Mounting the sensor 5. After you are finished installing and have made sure the control unit is Install the sensor in the booth as shown functioning properly, check the line for in the figure below. overheat shutoff protection for short 2.
  • Page 6 l Mount the infrared emitter according to the mounting instructions. screws lUnscrew the two screws of the clamped clamped covering covering for connecting the control cable with the distributor block. Insert the plug into the distributor block and retighten the two screws.
  • Page 7: Operation

    Operation Temperature selection switch Operation On/Off Red LED (emitters on) Green LED (operation) Light On/Off lThe IR heat booth can be started up remaining areas of the booth; particularly areas not reached by the by pressing the top button. The green radiation from the IR emitters.
  • Page 8: Guarantee

    Direct warranty processing with our service department is in this case not possible. Equipment start-up date: Stamp and signature of the authorized electrician: Service Address: EOS-Werke Günther GmbH Adolf-Weiß-Str. 43 35759 Driedorf-Germany +49 (0)2775 82-240 fax +49 (0)2775 82-455 servicecenter@eos-werke.de www.eos-werke.de...

Table of Contents