Panasonic SD-253 Service Manual page 16

SD-253
3.10. Ground wire A assembly
1. Remove the screw and the spring washer that secures the
ground wire A assembly.
2. Raise the two claws of the ground plate up with the flat-
blade screwdriver.
3. Remove the ground plate from the heater terminal.
Caution:
Before attaching the ground plate to the heater, restore
the connector to its original shape so that it will firmly
attach to the heater.
3.11. Sensor assembly
1. Remove the screw that secures the sensor fixing plate.
2. Remove the sensor assembly including the thermal fuse
unit.
3. Remove the connector.
No.
1 Screw
2 Spring washer
3 Ground wire A Ass'y
4 Ground plate
5 Flat-blade screwdriver
6 Heater
No.
1 (+) screw (short) driver
2 Screw
3 Angle Unit
4 Heater case Ass'y
5 Sensor fixing plate
6 Thermal fuse Unit
7 Sensor Ass'y
16
Fig.16
Parts Name
Fig.17
Parts Name