Optional Components; Optional Unit Size 6X Components; Tools Required; General Torque Tightening Values - GE AF-650 GP Operating Instructions Manual

1.7 Optional Components

1.7.1 Optional Unit Size 6x components

Units are manufactured in different configurations due to the optional com-
ponents available. Depending on the unit configuration, optional equipment
may be mounted in the inverter, rectifier or option cabinet. The table below
lists the components available and the cabinet where it is factory installed.

1.8 Tools Required

Operating Instructions for the Drives Series Frequency Converter
Metric socket set 7–19 mm
Socket extensions 100 mm–150 mm (4 in and 6 in)
Torx driver set T10 - T50
Torque wrench 0.675–19 Nm (6–170 in-lbs)
Needle nose pliers
Magnetic sockets
Ratchet
Hex wrench set
Screwdrivers Standard and Philips

1.9 General Torque Tightening Values

For fastening hardware described in this manual, the torque values in the table below are used. These values are not intended for SCR, diode, or IGBT fasteners.
See the instructions included with those replacement parts for correct values.
Shaft Size
M4
M5
M6
M8
M10
M12
Table 1.7: Torque Values Table
Optional Component
Mains Options
AC fuse
Disconnect
A1 RFI filter
Load share
Additional Tools Recommended for Testing
Digital volt/ohmmeter (must be rated for 1200 VDC for 690 V units)
Analog voltmeter
Oscilloscope
Clamp-on style ammeter
Test cable p/n 6KAF6H8766
Signal test board p/n 6KAF6H8437
Power supply: 610 - 800 VDC, 250 mA to supply external power to 4
power cards and the control card.
Power supply : 24 VDC, 2 A for external 24 V power supply.
Driver Size Torx / Hex
T-20 / 7 mm
T-25 / 8 mm
T-30 / 10 mm
T-40 / 13 mm
T-50 / 17 mm
18 mm / 19 mm
High Power Service Manual for Unit Sizes 6x
Cabinet Location
Rectifier or inverter
Option
Option
Rectifier
Torque (in-lbs) Torque (Nm)
10
20
35
85
170
170
1
1.0
2.3
4.0
10
19
19
9