Colour Coding; Symbols And Markings - Bosch MUZ9MX1 Instruction Manual

Overview
Please fold out the illustrated pages.
Blender attachment
X Fig. A
1 Glass blender jug
a Container made of ThermoSafe glass
b Scale
2 Lid
a Filling opening
b Locking cap / measuring jug
with scale
3 Blade insert
a Blade drive (red)
b Blender knife
c Seal
d Positioning lugs (4)
4 Blade holder
a Marking L
b Locking for blade holder (2)
Before using for the first
time
Before the new accessory can be used,
it must be fully unpacked, cleaned and
checked.
Caution!
Never operate a damaged accessory!
■ Remove all accessories from the
packaging and dispose of all packing
materials.
■ Check that all the parts are present and
examine them for obvious damage.
X Fig. A
■ Thoroughly clean and dry all parts
before using for the first time.
X "Cleaning and maintenance" see
page 11

Colour coding

The drives of the base unit each
have different colours (black,
yellow and red). This colour coding
system can also be found on the accesso-
ries. Only use this accessory on the rear
drive marked in red.
MUZ9MX1_EU_8001017418.indb 9

Symbols and markings

Symbol Meaning
Fit blade holder: Align
symbol G and the handle of
the blender jug.
L
Lock blade holder: Turn
until symbol 0 and the handle
of the blender jug are aligned.
Glass blender jug
The "ThermoSafe" glass blender jug is
made of special, highly heat-resistant
b orosilicate glass. This lets you process
very hot, even boiling ingredients.
The glass blender jug is suitable for
p rocessing the following quantities:
Maximum processing quantities
Solid food
Liquids
Hot or frothing liquids
Preparation
W Risk of injury
– Do not reach into the knife. Grip the
blade insert by the plastic only.
– Before attaching or removing the
a ccessory, wait until the drive has come
to a standstill and pull out the mains
plug.
Caution!
Never use the blade insert without the seal.
X Image sequence B
Important: Only prepare the base unit as
described in the main operating instruc-
tions. The accessory can only be operated
if the bowl is fitted properly.
1. Fit the seal to the blade insert.
2. When fitting the blade insert, always
observe the position of the 4 lugs. Align
the 2 opposite lugs to the markings 0.
3. Hold the blade insert at an angle when
inserting in the blade holder. Possibly
support it underneath with the other
hand.
Overview en
max. 100 g
max. 1.5 l
max. 0.5 l
9
01.07.2016 11:15:17