Scotts SP6211 Operator's Manual page 23

E
4. Inspect belt (E) for excessive wear or damage.
TO REPLACE DRIVE BELT:
NOTE: On model SP6211 only, the anti-rotation bracket
must be removed prior to pushing the drive sheave
forward to remove the drive belt.
Picture Note: View is from underside of differential.
1. Remove cap screw (F) and anti-rotation bracket.
c
CAUTION: Avoid injury! Wear protective
eyewear when removing belt from drive sheave.
Tension spring may come loose.
G
2. Push drive sheave (G) forward to relieve spring tension
SERVICE
M96557
F
MX1578
H
MX1576
Service - 19
on belt.
NOTE: Tension spring (H) may come loose when belt
is removed.
3. Remove belt from drive sheave.
4. Move belt into underside of mower deck.
5. Turn mower onto its LEFT SIDE.
6. Remove mower blade. (See Check Blade in this
section.)
7. Remove drive belt from blade sheave.
8. Install new drive belt to blade sheave.
I
J
9. Insert belt through deck opening (I).
10.Install tension spring (H) if removed.
11.Check that drive belt is installed on engine sheave.
12.Push drive sheave (J) forward and install belt to sheave.
13.Install anti-rotation bracket and secure with cap screw.
14.Install mower blade.
• Tighten mower blade bolt to 75 N•m (55 lb-ft).
15.Lower mower.
16.Slide control cables into belt shield notch.
17.Install belt shield and connect spark plug wire.
H
M96554