Scotts SP6211 Operator's Manual page 15

OPERATING
sunlight in Fall to help store food for Winter. A thick layer of
mulched leaves can prevent sunlight from getting to grass
and smother it. You may have to mow with grass bag to
remove this layer.
Mulch leaves only when they are dry.
Mulching wet or damp grass or leaves may cause
problems:
• Clippings and leaves may build up on the underside of
the mower deck.
• Cut grass and leaves may form clumps.
• Leaves may not be cut into small bits.
• Engine will work harder and use more fuel.
• Clean underside of mower deck after mulching wet or
damp grass.
If possible cut only top 1/3 of grass at a time.
Use a different mowing pattern each time you mow.
Overlap mowing paths 50–100 mm (2–4 in.) instead of
cutting a full swath with each pass.
Operate mower at a slower ground speed. Mulching takes
more power.
Keep blade sharp. Check it often.
Keep underside of deck clean.
If clippings are not dispersed evenly or quality of cut is
marginal, raise cutting height one or more positions.
After Mowing
• STOP engine. Let it cool. This will help prevent starting
a fire when you store the mower.
• Remove and shake bag to remove all clippings. This will
help to prevent deterioration of bag and starting a fire.
• Clean top of deck, engine, and chute with brush or
compressed air, if possible. This will help to prevent buildup
and starting a fire.
• Spray under deck with water under pressure to remove
corrosive lawn chemicals and buildup.
• Put mower in safe storage.
Operating - 11