Scotts SP6211 Operator's Manual page 26

21-inch walk-behind rotary mowers
Table of Contents

Advertisement

raised position.
B
A
2. Remove plastic hubcaps (A).
• Use a screwdriver in slot (B) to pry the hubcap from
each wheel.
D
3. Remove locknut (C) and washer (D).
4. Remove wheel from each axle.
E
5. Apply a light coating of grease to each axle (E).
6. Install wheels, hardware and hubcaps.
7. Lower mower.
8. Repeat procedure on other side of mower.
SERVICE
M93049
C
M93051
M93050
Check Blade
c
CAUTION: Avoid injury! Service blade safely:
• STOP engine. Let it cool.
• Disconnect spark plug wire.
• Wear gloves or wrap blade with a rag.
IMPORTANT: Avoid damage!
Turn mower on its LEFT SIDE to help prevent air
cleaner damage and hard starting.
NOTE: Sharpened edges on blade tips must face
upward when installing blade.
CHECK BLADE:
• Replace damaged blade.
A
• Tighten Bolt (A) to 75 N•m (55 lb-ft).
• Sharpen dull blade. (See Sharpening Blade in this
section.)
TO REMOVE BLADE:
• Remove bolt (A), washer (B), and blade.
Sharpening Blade
c
CAUTION: Avoid injury! Wear gloves and
goggles when sharpening, balancing or
installing blade.
IMPORTANT: Avoid damage! Balance blade after
you sharpen it. An unbalanced blade may cause
excessive vibration.
Sharpen blade with grinder, hand file or electric blade
Service - 22
B
M87085

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sp6213

Table of Contents