Advertisement
Hamersley Mk2 Insert
Installation
(continued)
Clearance to combustibles & Gason Zero Clearance Box (ZCV) installation
The Jindara Hamersley Insert conforms to AS/NZS 2918:2001 Appendix B, when the appliance is placed in relation
to combustible surfaces. For additional clearance details, or to access the Jinidara Hamersley Insert thermal
clearance test report – HCMG-15-067 – please contact the Jindara dealer from whom you purchased your heater.
The Gason ZCV box is an approved cabinet that allows certain Jindara Insert wood heaters, in conjunction with a
triple skin ue system to be installed within a non-masonry replace in accordance with AS/NZS 2918:2001.
690
100
30
836
50
Vent
Figure 2. ZCB Installation detail
Triple skin
Flue
1063
763
Zero
660
Clearance
Box
545
18mm Bellis Board
or Cement Sheet min.
Vent
Villaboard can overlap clearance gap
between ZCB and frameing, and run
over the front of the ZCB. Do not silicon or
adhere villaboard to ZCB as heat expansion
of ZCB will cause cracking.
4
Hamersley Mk2 Insert
Installation
(continued)
Gap 25mm
Batten
Ceiling
Ceiling Plate
See clause 4.6.3(b) of AS/NZS 2918:2001
Flue pipe
150mm dia
Example of sloped ceiling penetration
Operating your Jindara Wood Heater
50
!
WARNING
Read these instructions
Starting your re
Place a
or paper in the bottom of the
paper or the
r. Set the air control to high and leave the main door open approximately 25mm. When the kindling
is burning, place about four pieces of small wood on top of the burning kindling. Once the wood is alight, close the main
door. After approximately 20 minutes, turn the air control down to medium and turn the fan on to low speed.
On the initial
-up you may detect smoke coming from the paint
the outside of the
. This is normal. It is suggested to well ventilate your home on the initial
our section 'Paint Curing and Care'.
The glass door
Always operate your heater with the door closed and locked. The only time you can leave the door open is on initial
lighting, or when reloading the heater.
Care of your glass
If you are burning good dry hard wood, you will have very little discolouration of your glass in a normal burning cycle.
If you aim for an overnight burn, you should not get much discolouration. You can control this by adjusting the air
control, moving from the left and slowly creeping the control to the right. After a number of days you will
position to suit your requirements and the fuel that you are using.
Flue pipe casings
Flue pipe casing
See clause 4.8 of AS/NZS 2918:2001
Flashing
Flashing
Heat sensitive roof
25mm
25mm
Gap 25mm
12mm
25mm
25mm
3 x
diameter
from active
to
heat sensitive
surface
DO NOT ATTEMPT TO OPERATE THIS APPLIANCE WITHOUT READING AND
UNDERSTANDING THESE OPERATING INSTRUCTIONS THOROUGHLY. FAILURE TO
OPERATE THIS APPLIANCE PROPERLY MAY CAUSE UNDUE DAMAGE TO THE
APPLIANCE OR RESULT IN A FLUE FIRE.
and place a large amount of small kindling on top. Ignite the
and from any oils that may be on the steel on
9
Rafter
Flue
pipe
Batten
25mm
Example of roof penetration
up. Please refer to
the right
Advertisement
