Download Print this page

Jindara Hamersley Mk2 Insert Installation Instructions Manual

Advertisement

Quick Links

Hamersley Mk2 Insert
Troubleshooting
(continued)
Smoke entering the room from the rebox when the door is open may be caused by
Insu cient length of ue ( ue to be 4500mm minimum underneath the base of heater to
underside of cowl)
Increase height of ue
Flue downdraught
Consult dealer or increase height of ue.
Creosote buildup in ue
Remove cowl and clean ue as per cleaning instructions. Check moisture content of wood.
Excessive ash build up
Some woods will give large amounts of ash despite how you run the heater. Others will give you very little.
Use the wood which is most convenient for you as long as it is dry. After a period of time you will get to
know when to empty your unit. Bark will give you excessive ash. Try not to burn it.
If you are burning wood that gives you charcoal, you may nd that after running the heater say for 8 hours
at maximum burn rate, the charcoal builds up excessively. Overnight burn will reduce this charcoal back to
a ne ash. If you are not ready to shut down for overnight burn when you next fuel the stove, load the
stove with only one piece of wood and lay it across the rebox on top of the charcoal. Open the air control
wide open and you will nd the charcoal will burn down with the one piece of wood. Repeat the process
until the ash level is signi cantly reduced.
1. Subject to clauses 2 & 3 of this Warranty, A.F. Gason Pty Ltd ACN 004 667 556 (Gason warrants the follow components of its heaters against defects in workmanship
and/or materials for the following periods from the date of purchase:
a) the rebox for ten years;
b) the paint nish for a period of twelve months if the Purchaser has followed the instructions provided by Gason in the Operation and Installation Instructions manual; and
c) all other components for twelve months except the glass, re brick lining or ba e plate if, in the opinion of Gason, these items have been damaged by impact.
2. This extended warranty does not apply;
a) if the heater is purchased from a person who has not been authorised by Gason to sell its products;
b) if, in the opinion of Gason, the heater or any other component has been subject to abuse, misuse, alteration, modi cation or has not been installed, operated or maintained in
accordance with the instructions provided by Gason; or,
c) to owners other then the original Purchaser.
3. If you believe that the heater you purchased contains a manufacturing defect and you wish to make a claim under this Warranty, please contact an authorised Gason service
centre to arrange for an assessment.
4. If, after assessing the heater, Gason determines that the heater contains a manufacturing fault, Gason may at its discretion:
a) replace the heater;
b) repair or replace speci c components of the heater; or
c) provide a full refund.
5. Parts replaced under warranty are warranted for the balance of their original warranty period.
6. If, at the discretion of Gason, the heater or any part needs to be replaced, serviced or repaired at an authorised Gason service centre, then the person claiming under this
Warranty must pay all costs associated with:
a) returning the heater; and
b) the delivery or collection of any new or repaired heater.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for
compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
Any bene ts you receive under these warranties are in addition to other rights and remedies that you may have as a consumer under a law in relation to the heater to which
these warranties relate.
These warranties are given by:
A.F. Gason Pty. Ltd.
Blake Street
Ararat VIC 3377
Please contact us if you have any queries on:
Phone: 03 53522151
or email us via the "Contact Us" section of our website: www.gason.com.au
A.F. Gason Pty Ltd reserves the right to modify or alter speci cations, material etc. in the interest of product improvement
WARRANTY
12
Operation & Installation Instructions
Rev*
Please keep these instructions for future reference.
Heating
A Division of A.F. Gason Pty. Ltd.
Hamersley Mk2 Insert
231551

Advertisement

loading

Summary of Contents for Jindara Hamersley Mk2 Insert

  • Page 1 Hamersley Mk2 Insert Troubleshooting (continued) • Smoke entering the room from the rebox when the door is open may be caused by • Insu cient length of ue ( ue to be 4500mm minimum underneath the base of heater to...
  • Page 2: Troubleshooting

    Undo the holding nut and pull the switch out. Disconnect the wiring from the power lead and remove the fan and switch. Convey the same to the authorised Jindara dealer from whom you purchased your unit for service.
  • Page 3: Installation

    Cleaning the glass WARNING This heater is to be installed into a masonry replace or a Jindara ZCV Generally the only time you will possibly need to clean your glass is after a long overnight burn. If you nd that you have Clearance cabinet.
  • Page 4 Rafter See clause 4.8 of AS/NZS 2918:2001 Flue The Gason ZCV box is an approved cabinet that allows certain Jindara Insert wood heaters, in conjunction with a pipe Batten triple skin ue system to be installed within a non-masonry replace in accordance with AS/NZS 2918:2001.
  • Page 5 • Ensure the ba e plate is rmly located. • Insert your Jindara Hamersley Insert into the ZCV. It is important that the base of the appliance is sitting on 2x • Ensure cast iron liners – side and back – are positioned correctly.
  • Page 6 Elevated installation Mantle Clearances Masonry In some instances it may be desirable, or required that the Jindara Hamersley Insert wood heater be installed into Plaster, timber, MDF etc. 1225 an existing replace which is raised above a combustible oor. In this situation, the minimum required hearth can...

This manual is also suitable for:

Kimberley m3 insert