Jindara Riverina SRS3 Insert Installation Instructions Manual

Advertisement

Quick Links

Riverina SRS3 Insert
(Continued)
Smoke entering the room from the rebox when the door is open may be caused by
Insu cient length of ue (Flue to be 4500mm minimum underneath the base of heater to
underside of cowl)
Increase height of ue
Flue downdraught
Consult dealer or increase height of ue.
Creosote buildup in ue
Remove cowl and clean ue as per cleaning instructions. Check moisture content of wood.
Excessive ash build up
Some woods will give large amounts of ash despite how you run the heater. Others will give you very little.
Use the wood which is most convenient for you as long as it is dry. After a period of time you will get to
know when to empty your unit. Bark will give you excessive ash. Try not to burn it.
If you are burning wood that gives you charcoal, you may nd that after running the heater say for 8 hours
at maximum burn rate, the charcoal builds up excessively. Overnight burn will reduce this charcoal back to
a ne ash. If you are not ready to shut down for overnight burn when you next fuel the stove, load the
stove with only one piece of wood and lay it across the rebox on top of the charcoal. Open the air control
wide open and you will nd the charcoal will burn down with the one piece of wood. Repeat the process
until the ash level is signi cantly reduced.
1. Subject to clauses 2 & 3 of this Warranty, A.F. Gason Pty Ltd ACN 004 667 556 (Gason warrants the follow components of its heaters against defects in workmanship
and/or materials for the following periods from the date of purchase:
a) the rebox for ten years;
b) the paint nish for a period of twelve months if the Purchaser has followed the instructions provided by Gason in the Operation and Installation Instructions manual; and
c) all other components for twelve months execpt the glass, re brick lining or ba e plate if, in the opinion of Gason, these items have been damaged by impact.
2. This extended warranty does not apply;
a) if the heater is purchased from a person who has not been authorised by Gason to sell its products;
b) if, in the opinion of Gason, the heater or any other component has been subject to abuse, misuse, alteration, modi cation or has not been installed, operated or maintained in
accordance with the instructions provided by Gason; or,
c) to owners other then the original Purchaser.
3. If you believe that the heater you purchased contains a manufacturing de fect and you wish to make a claim under this Warranty, please contact an authorised Gason service
centre to arrange for an assessment.
4. If, after assessing the heater, Gason determines that the heater contains a manufacturing fault, Gason may at its discretion:
a) replace the heater;
b) repair or replace speci c components of the heater; or
c) provide a full refund.
5. Parts replaced under warranty are warranted for the balance of their original warranty period.
6. If, at the discretion of Gason, the heater or any part needs to be replaced, serviced or repaired at an authorised Gason service centre, then the person claiming under this
Warranty must pay all costs associated with:
a) returning the heater; and
b) the delivery or collection of any new or repaired heater.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for
compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
Any bene ts you receive under these warranties are in addition to other rights and remedies that you may have as a consumer under a law in relation to the heater to which
these warranties relate.
These warranties are given by:
A.F. Gason Pty. Ltd.
Blake Street
Ararat VIC 3377
Please contact us if you have any queries on:
Phone: 03 53522151
or email us via the "Contact Us" section of our website: www.gason.com.au
A.F. Gason Pty Ltd reserves the right to modify or alter speci cations, material etc. in the intrest of product improvement

WARRANTY

12
Operation & Installation Instructions
Rev A
Please keep these instructions for future reference.
Riverina SRS3 Insert
231312

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Riverina SRS3 Insert and is the answer not in the manual?

Questions and answers

Summary of Contents for Jindara Riverina SRS3 Insert

  • Page 1 Riverina SRS3 Insert Troubleshooting (Continued) • Smoke entering the room from the rebox when the door is open may be caused by • Insu cient length of ue (Flue to be 4500mm minimum underneath the base of heater to underside of cowl) Increase height of ue •...
  • Page 2: Troubleshooting

    Riverina SRS3 Insert RiverinaSRS3 Insert Troubleshooting Troubleshooting (Continued) Read and follow these instructions carefully before installing and WARNING using this appliance • Noisy Fan Turn the power o and remove the three pin plug from the power point. SAVE THESE INSTRUCTIONS Remove the four screws that hold the front fan access panel.
  • Page 3 Carefully remove ba e plate and put it to one side. Close the heater door. Obtain a 150mm ue brush from your local purchased your heater. Jindara Dealer and proceed up onto your roof. Remove the cowl. Slowly push the ue brush down the chimney until it THIS APPLIANCE WEIGHS IN EXCESS OF 120 KILOGRAMS. EXTREME CARE stops.
  • Page 4 (Continued) Clearance to combustibles & Gason Zero Clearance Box (ZCB) installation The Jindara Riverina Insert conforms to AS/NZS 2198:2001 Appendix B, when the appliance is placed in relation to DO NOT ATTEMPT TO OPERATE THIS APPLIANCE WITHOUT READING AND WARNING combustible surfaces, as per test report number HCMG/13/030.
  • Page 5 Riverina SRS3 Insert Riverina SRS3 Insert Installation Operating your Eureka Installation (Continued) (Continued) ZCB installation notes Placement of rebricks in rebox Take the rebricks out of the heater. They are to be placed so that they stand on end against the rear and two side walls •...
  • Page 6 Elevated installation In some instances it may be desirable or required that the Jindara Riverina Insert woodheater be installed onto a step of an existing replace or mid-wall inside a Gason ZCB. In either of these situations, a step or structure must be constructed of non-combustible material and withstand the combined weight of the appliance and ZCB.

Table of Contents