Enabling Dhcp Networking - Nasuni Edge Initial Configuration Manual

Enabling DHCP Networking

Important: After making any network changes, you must use the Nasuni Edge Appliance to enter
those settings so that the Nasuni Edge Appliance is consistent with the platform.
This applies to all network changes.
To enable DHCP networking:
1. Access the console for the Nasuni Edge Appliance. For the Nasuni Edge Appliance hardware
appliance, use a keyboard and monitor attached to the hardware appliance. For the Nasuni
Edge Appliance virtual machine, use the virtual machine console window. The console prompt
appears.
2. Press Enter to access the Service menu. The login prompt appears. Enter the username and
password. The login username is service, and the default password is service. The Service
Menu appears.
3. Enter editnetwork at the prompt. The network prompt appears.
4. Enter the following command:
setaddr dhcp
Press Enter. The setaddr dhcp command runs.
Nasuni Edge Appliance Initial Configuration Guide 8.3
Figure A-16: Console prompt.
Figure A-17: Service Menu.
Figure A-18: Network prompt.
Overview
99